Siemens SIMATIC Ident Function Manual page 105

Error mes- Description
sage
(hex)
0xE1FE84 General transponder error
0xE1FE85 The transponder has too little power to execute the command.
0xE2FE01
Field disturbance on reader
•
Reader is receiving interference pulses from the environment.
– External interference field. The interference field can be detected with the "inductive field indicator"
of the STG.
– The distance between two readers is too short and does not correspond to the configuration guide-
lines
– The connecting cable to the reader is disrupted, too long or does not comply with the specification
Too many transmit errors
•
The transponder was unable to receive the command or the write data from the communications mod-
ule correctly even after several attempts.
– The transponder is positioned exactly in the limit area of the transmission window
– Data transmission to the transponder is being affected by external interference
CRC sending error
•
– The transponder reports CRC error frequently (transponder is positioned in the limit area of the
reader; transponder and/or reader has a hardware defect)
Only during initialization: CRC error on receipt of acknowledgement from transponder (cause as for
•
field interference on the reader)
When formatting, the transponder must be in the transmission window of the reader, otherwise a
•
timeout error will occur, in other words:
– The transponder is located exactly in the limit area of the transmission window
– The transponder is consuming too much power (defective)
– Bad FORMAT parameter setting for transponder EEPROM
RF600:
•
– No ETSI channel free
– Wrong communications standard selected in the "INIT" command
– Bad expert parameter
– Power check of the ETSI wireless profile is incorrect
0xE2FE02
More transponders are located in the transmission window than can be processed at the same time by
•
the reader.
RF620R/RF630R: Transponder power supply close to limit.
•
Increase the antenna power or reduce the distance to the transponder.
0xE2FE81 There is no transponder with the required EPC-ID in the transmission window or there is no transponder at
all in the antenna field.
0xE2FE82 The requested data is not available.
0xE2FE83 The transponder signals a CRC error.
0xE2FE84 The selected antenna is not enabled.
0xE2FE85 The selected frequency is not enabled.
0xE2FE86 The carrier signal is not activated.
0xE2FE87 There is more than one transponder in the transmission window.
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
5.2 Errors from the communications module/reader
Error messages
105