Toshiba ACE-tronics G9 ASD Installation And Operation Manual page 67

Program Mode Menu Navigation
rogram
Primary Menu
S W
TARUP
C H
RANE /
CRANE / HOIST
ACE-tronics G9 ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
The following table lists the menu items of the Program mode and maps the flow of the menu selections.
The Parameter Numbers for the listed functions are provided where applicable.
The functions listed may be viewed, or selected and changed as mapped below or via the Direct Access
method: Program  Direct Access  Applicable Parameter Number.
Program Mode Menu Navigation
Sub Menu
IZARD See the section titled
Motion Control
OIST
Speed Control
Express Stop
Plugging
Creep Control
Super Creep Control
Limit-Switch Control
Parameter Name
Startup Wizard Requirements on pg. 42
Motion Control
Speed Control
Preset Speed 1
Preset Speed 2
Preset Speed 3
Preset Speed 4
Express Stop Enable
Express Stop Deceleration Time
Plugging Enable
Plugging Acceleration Time
Plugging Deceleration Time
Creep Multiplier 1
Creep Multiplier 2
Creep Speed Lower Limit
Super Creep Pulse Count
Super Creep Repeat Delay
Super Creep Speed
Upper-Limit Speed at Slow-Speed Limit-Switch UP
Deceleration Time at Slow-Speed Limit-Switch UP
Stopping Time at Stop Limit-Switch UP
Upper-Limit Speed at Slow-Speed Limit-Switch DOWN
Deceleration Time at Slow-Speed Limit-Switch DOWN
Stopping Time at Stop Limit-Switch DOWN
Limit-Switch Stopping Method
Parameter
Number
for Startup Wizard setup information.
F985
F986
F018
F019
F020
F021
F493
F511
F494
F514
F515
F490
F491
F492
F863
F864
F865
F294
F283
F284
F293
F285
F286
F282
57