Toshiba ACE-tronics G9 ASD Installation And Operation Manual page 211

F814
Point 2 Frequency
Program  Communications  Communication Reference Adjust
This parameter is used to set the gain and bias of the Reference speed control
input.
This parameter sets the Point 2 Frequency.
Changes made to this parameter require that the power be cycled (off then on)
for the changes to take effect.
See F811 for additional information on this setting.
RS485 4-Wire Baud Rate
Program  Communications  Communication
This parameter sets the RS485 baud rate.
Changes made to this parameter require that the power be cycled (off then on)
for the changes to take effect.
Settings:
9600 bps
19200 bps
38400 bps
RS485 Send Wait Time
Program  Communications  Communication
This parameter sets the RS485 response delay time.
Changes made to this parameter require that the power be cycled (off then on)
for the changes to take effect.
ACE-tronics G9 ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Direct Access Number — F814
Parameter Type — Numerical
Factory Default — 60.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F820
Parameter Type — Selection List
Factory Default — 19200
Changeable During Run — Yes
Direct Access Number — F825
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 2.00
Units — Seconds
F825
201