Selection/Deselection Of Tool Monitoring - Siemens SINUMERIK Series Function Manual

W4: Grinding-specific tool offset and tool monitoring
17.4 Grinding-specific tool monitoring
When is the speed limit value recalculated?
The speed limit value is recalculated:
● when the monitoring function is selected,
● when the online offset values (wear parameters) are altered.
Monitor reactions
The system reacts as follows when the speed monitor responds:
● The speed is restricted to the limit value
● Interface signal:
DB31, ... DBX83.6 = 1 ⇒ Speed monitoring limit reached
DB31, ... DBX83.6 = 0 ⇒ Speed monitoring limit not reached
Note
No error reaction is initiated internally in the control system.
17.4.4

Selection/deselection of tool monitoring

Part program commands
The following part program commands are provided for selecting and deselecting the
grinding-specific tool monitor of an active or inactive tool:
Command
TMON
Tool monitoring ON
TMOF
Tool monitoring OFF
(T number)
TMON
Tool monitoring ON (T No.)
(T number)
TMOF
Tool monitoring OFF (T No.)
(0)
TMOF
Tool monitoring OFF (0)
828
and
DB31, ... DBX83.6 (speed monitoring)
is output.
Meaning
Selection of tool monitoring for the active tool in the channel.
Deselection of tool monitoring for the active tool in the channel.
Selection of tool monitoring for a non-active tool with T number.
Deselection of tool monitoring for a non-active tool with T number.
Deselection of tool monitoring for all tools.
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions