Signals From Axis/Spindle (Db31; Kinematic Transformation (M1); Signals From Channel (Db21 - Siemens SINUMERIK Series Function Manual

Z2: NC/PLC interface signals

18.6 Kinematic Transformation (M1)

18.5.2

Signals from axis/spindle (DB31, ...)

DB31, ...
DBB68 Axis/spindle replacement
Edge evaluation: Yes
Signal state 1 or The current axis type and currently active channel for this axis is displayed.
edge change 0 → 1
With axis replacement by the PLC, the bit meanings of the signal from axis/spindle DB31, ...
DBB68:
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5:
Bit 6:
Bit 7:
Signal state 0 or
edge change 1 → 0
Corresponding to .... DB31, ... DBB8 (Axis/spindle replacement)
MD20070 $MC_AXCONF_ASSIGN_MASTER_USED
(Machine axis number valid in channel)
MD30550 $MA_AXCONF_ASSIGN_MASTER_CHAN
(Initial setting of channel for axis replacement)
Special cases, errors,
...
18.6 Kinematic Transformation (M1)
18.6.1

Signals from channel (DB21, ...)

DB21, ...
DBX33.6 Transformation active
Edge evaluation: No
Signal state 1 or The NC command
edge change 0 → 1 corresponding block has been processed by the NC and a transformation is now active.
Signal state 0 or No transformation active.
edge change 1 → 0
References Programming Guide Advanced
Function Description, Special Functions; 3-Axis to 5-Axis Transformation (F2)
886
Signal(s) updated: Cyclic
A NC axis/spindle in channel
B ...
C ....
D NC axis/spindle in channel
New type requested from PLC
Axis replacement possible
neutral axis/spindle as well as command/oscillation axes
PLC axis/spindle
Signal(s) updated: Cyclic
,
TRANSMIT TRACYL
, or is programmed in the part program. The
TRAANG TRAORI
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions