GE ApexPro Service Manual page 152

Parts lists, drawings and replacement
7-34
9. Using a phillips screwdriver, remove the screw securing the temperature sensor
at the front left corner of the chassis floor, behind the left edge of the chassis fan.
NOTE
Note the position of the temperature sensor DIP switches for re-assembly.
10. Remove the temperature sensors and the associated temperature sensor wire
harnesses, cutting/removing any ties as required.
11. Reverse the steps in this procedure to install the temperature sensors.
ApexPro™ Telemetry
Number Position
1 OFF
2 ON
3 OFF
4 ON
077A
2001989-203C