Drive Filter; Chassis Cover - GE ApexPro Service Manual

Parts lists, drawings and replacement

Drive filter

Chassis cover

7-6
1. Turn the latch securing the front service door on the front panel of the ATS and
open the door.
2. Using a phillips screwdriver, remove the two screws securing the drive filter
cover.
3. Remove the cover and filter.
4. Reverse the steps in this procedure to install the drive filter.
1. Complete the preparation procedures.
7-3.
2. Using a phillips screwdriver, remove the 4 screws securing the front side of the
cover.
3. Using a phillips screwdriver, remove the 2 screws securing the back side of the
cover.
4. Slide the cover backwards until the lip on the front of the cover clears the groove
in the chassis. Lift and remove the cover.
5. Reverse the steps in this procedure to install the chassis cover.
ApexPro™ Telemetry
See Field replacement preparation on page
012A
041A
042A
2001989-203C