Status Data; Light-Emitting Diode (Led) Indications - GE PACSystems RX3i User Manual

5.1 Status Data

The EIS001 produces a total 100 words to supply status information to the controlling RX3i CPU. As
part of the COMMREQ instruction to parameterize the EIS001 module, a 100-word region can be
specified for real time diagnostics on the module.
For each bank of 32 status bits, a default beginning reference (the next available %I) for the status
bits is automatically assigned by Proficy Machine Edition (PME). These assignments may be changed
by clicking on the EIS001 and keying in different %I references, or by switching the module to
variable mode, and using symbolic addresses.
Refer to Appendix A Definition of the Status Area for more details on diagnostic information.

5.2 Light-Emitting Diode (LED) Indications

The three LEDs in the module header provide a visual indication of the EIS001 module status.
Additionally, each RJ-45 port is equipped with a pair of LEDs to indicate the status of the
corresponding port.
LED
ETHERNET OK
LAN OK
LOG EMPTY
ETHERNET OK
LAN OK
LOG EMPTY
ETHERNET OK
LAN OK
LOG EMPTY
ETHERNET OK
LAN OK
LOG EMPTY
ETHERNET OK
LAN OK
LOG EMPTY
ETHERNET OK
LAN OK
LOG EMPTY
Port LEDs (one pair for Port 1A, second pair for Port 1B)
100 Mbps
LINK
GFK-2949C
State
Fast Blink
Off
Off
Slow Blink
Off
Off
Slow Blink*
On/Traffic/Off
Slow Blink*
On
On/Traffic/Off
On/Off
Blink error code
Off
Off
Slow Blink*
(* All LEDs blink in
Slow Blink*
unison)
Slow Blink*
On
Off
Rapid Blink
Off
July 2017
Performing Diagnostics
Waiting for Ethernet
configuration from CPU
(* EOK and STAT
Waiting for IP Address
blink in unison)
Operational
Hardware failure, refer to
PACSystems RX7i & RX3i TCP/IP
Ethernet Communications User
Manual, GFK-2224, section
12.4 for blink code definitions.
Firmware Update (pattern is the
same for awaiting or
performing load)
100 Mbps Active
100 Mbps Not Achieved
Traffic Detected on Port
No Traffic Detected on Port
Chapter 5. Diagnostics
Indicates
29