Replacement Of The M4 Back-Geared Motor; Replacement Of The Km10, Km11 Contactors And The Ka9 Relay; Replacement Of The E1 Clutch - Electrolux IC4 4819 FFS Service Manual

Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair

Replacement of the M4 back-geared motor:

Remove / Assembly:
1. Remove the left side frame of the machine.
2. Loosen the support of the faulty back-geared motor to remove the chain.
3. Remove the back-geared motor and replace it by a new one.
4. Put the chain on the new back-geared motor.
5. Adjust the support to tighten the chain.
6. Put back the frame.

Replacement of the KM10, KM11 contactors and the KA9 relay:

If the contact of the contactor or relay do not stick when the contact coil is supplied manually,
this means that the contactor or relay is faulty.
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty contactor or relay.
3. Remove the contactor or the relay and replace it by a new one.
4. Connect the wire on the new contactor or relay.
5. Put back the frame.

Replacement of the E1 clutch:

If the folding arm don't move even if the clutch is supplied in 230V, this means that the clutch is
faulty.
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty clutch.
3. Remove the clutch of the folding arm.
4. Loosen the clutch box in order to release the chain.
5. Remove the chain using the fast fastener.
6. Remove the clutch box and replace it by a new one.
7. Put the chain on the new clutch.
8. Put the folding arm on the new clutch.
9. Connect the wire on the new clutch.
10. Put back the frame.
04102011/GB
19.2013
Longitudinal folding: PLIVIT
(electricity, steam, water, gas, compressed air...).
32
15