Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the M715 back-geared motor «Advance/Return clamps»:
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty back-geared motor.
3. Remove the transmission belt between the back-geared motor and the control satellite.
4. Remove the back-geared motor support of the casing.
5. Remove the drive pulley of the back-geared motor.
6. Remove the back-geared motor and replace it by a new one.
7. Put the drive pulley on the new back-geared motor.
8. Put the belt.
9. Connect the wire on the new back-geared motor.
10. Put back the frame.
Replacement of the M723 motor «Spacing clamps»:
Remove / Assembly:
1. Remove the splash guard.
2. Disconnect the wire of the faulty motor.
3. Remove the transmission belt.
4. Remove the drive pulley of the motor.
5. Remove the motor and replace it by a new one.
6. Put the drive pulley on the new motor.
7. Put the belt.
8. Connect the wire on the new reducer-motor.
9. Put back the splash guard.
04102011/GB
21-2012
Feeding: Motion
(electricity, steam, water, gas, compressed air...).
30
7