Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the E2 and E3 electromagnets:
Remove / Assembly:
1. Remove the splash guard where the electromagnet is faulty.
2. Disconnect the wire of the faulty electromagnet.
3. Remove the electromagnet and replace it by a new one.
4. Connect the wire of the new electromagnet.
5. Adjust the cam according to the below paragraph 'Setting'.
6. Switch on the machine and check the operation of clamps.
7. Put back the splash guard.
Setting (fi g 1):
1. Compress the spring of the electromagnet.
2. Loosen the screw 'A' and put the cam into obstinate with the clamp.
3. Tighten the screw 'A'.
4. Slacken the spring.
1
NOTE : Turn the o-rings of 1/8 of turn,
in order to relieve their surface
with the clamp during the closing.
04102011/GB
21-2012
Feeding: Clamps System
(electricity, steam, water, gas, compressed air...).
clamp
o-ring
31
A
cam
5