Electrolux IC4 4819 FFS Service Manual page 285

Service
Manual
SET CUSTOMIZED FOLDS TABLE
0. Factory folds table
Length =
0 ≤ Length < 0
Fold 1
Fold 2&3
Fold 4&5
Fold 6&7
=> Last fold
& offset
04102011/GB
19.2013
Longitudinal folding: PLIVIT
Validate.
 Screen "SET CUSTOMIZED FOLDS TABLE"
The «SET CUSTOMIZED FOLDS TABLE» screen displays
as opposite.
0
CAUTION: all modifi cations of parameters
on this screen can only executed by a
(0): 0
(0): 0
qualifi ed and informed person.
(0): 0
(0): 0
= 0
= 0
Before any change of folds tables, don't forget to set the
main frequency (50 or 60 Hz) of the machine (see page
30 to 32, Advanced Setting\Machine Confi guration\Mains
frequency).
Introduce the linen test in the machine, the value
'Length' goes incriminated progressively according to the
measurement of the linen.
At the end of the measurement of the linen, the lengths of
folding `Fold 1 ', `Folds 2&3 ', `Folds 4& 5 ', `Folds 6&7 ',
`Last fold' and `& offset' will display on the screen.
The lengths of folding, value by defect, are displayed
between brackets.
Then select the line to make a change by pressing the
arrow.
To decrease or increase the value, press '+' or '-'.
ATTENTION : To ensure a correct result, make sure that
the 1
st
has the greatest value.
Then validate
Re-introducing again the linen test in the machine and re-
adjust the lengths of folding as many times as necessary.
fold is ≥ 23, the last fold ≥ 23 and the before last fold
32
5