Repair; Replacement Of The Dp6 Photocell; Replacement Of The Dp7 Photocell - Electrolux IC4 4819 FFS Service Manual

Service
Manual
Before any intervention it is essential to cut off all supply of the machine

Repair

Replacement of the DP6 photocell:

Under voltage, the indicator of the photocell must operated according to the following
conditions:
- presence of linen
- no presence of linen
If the above conditions are not validate, the photocell is faulty.
Remove / Assembly:
1. Disconnect the wire of the faulty photocell.
2. Remove the photocell and replace it by a new one.
3. Connect the wire on the new photocell.
4. Adjust the new photocell according to the below paragraph.
Setting of the photocell:
1. Fix the cell to 5 mm relative to feeding
table.
2. Switch on the machine.
3. Put a object on the feeding table, the
indicator of the photocell must lit. If it is
not the case, also adjust the photocell.

Replacement of the DP7 photocell:

Under voltage, the indicators of the photocell must operated according to the following
conditions:
- presence of linen
- no presence of linen
If the above conditions are not validate, the photocell is faulty.
Remove / Assembly:
1. Disconnect the wire of the faulty photocell.
2. Remove the photocell and replace it by a new one.
3. Connect the wire on the new photocell.
4. Adjust the new photocell according to the refl ector fi xed on the folder stop tube.
04102011/GB
19.2013
Longitudinal folding: PLIVIT
(electricity, steam, water, gas, compressed air...).
: indicator is on
: indicator is off
: green indicator
: green indicator + orange indicator.
32
11