Table of Contents
Advertisement
PTP 250 User Guide
Connecting to the network
To connect to the network, proceed as follows:
Disconnect the local PC from the PoE power supply at the Master and Slave
1
sites.
At each site, connect the PoE power supply DATA IN ports to a router port,
2
switch port or other network equipment in the data network
using the CAT5e cable that was prepared for this purpose in
PoE power supply to network equipment cable
Check that the Master and Slave units are reachable from the network
3
management system by opening the web interface to the management
agents, or by requesting ICMP echo response packets using the Ping
application. The network management system will normally be
geographically remote from the sites, so it may be necessary to request that
this action is completed by co-workers at the management center.
Check the data network for correct operation across the wireless link. This
4
may be by requesting ICMP echo response packets between hosts in the
connected network segments, or by some more structured use of network
testing tools.
Select menu option Home or Status and check that the Wireless Link Status
5
is 'Up' on both units. If it is not 'Up', refer to
on page 7-15.
phn-2182_002v000
May 2011
Connecting link to the network
(Figure
Preparing the
on page 5-30.
Managing link status and alerts
6-3)
6-35
Advertisement
Table of Contents
