Table of Contents
Advertisement
PTP 250 User Guide
Connecting to the unit
Perform this task to connect a management PC to the unit, power it up and open the
web interface.
This task consists of the following procedures:
x
Configuring the management PC
x
Connecting to the PC and powering up
x
Logging into the web interface
Configuring the management PC
NOTE
To configure the local management PC to communicate with the PTP 250, proceed as
follows:
1
2
3
4
5
phn-2182_002v000
May 2011
Install Java on the management PC (if not already installed), as this is used
by the PTP 250 web interface.
Select Properties for the Ethernet port.
Select the Internet Protocol (TCP/IP) item as shown in
Click on Properties.
Enter an IP address that is valid for the 169.254.X.X network, avoiding:
169.254.0.0 and 169.254.1.1 and 169.254.1.2
A good example is 169.254.1.3
Enter a subnet mask of 255.255.0.0.
Leave the default gateway blank.
on page
6-3
on page
6-5
on page
6-6
(Figure
6-2).
Connecting to the unit
Figure
6-1.
6-3
Advertisement
Table of Contents
