Table of Contents
Advertisement
Connecting to the unit
NOTE
Logging into the web interface
To log into the web interface as a system administrator, proceed as follows:
Start the web browser from the management PC.
1
2
Type the IP address of the unit (factory default is 169.254.1.1) into the
address bar. Press ENTER.
For user security, Motorola digitally signs its applications. On the first
login, the digital signature confirmation is displayed
'Always trust content from this publisher' box and select Run.
The digitally signed Java app splash screen is displayed
followed by the Login page.
3
When the Login page is displayed
and Password (default 'motorola') and select Login.
4
On the first login to a new unit, or on the first login to a unit that has been
reset to full or partial default configuration, the Change Password page is
displayed
5
On the first login to a new unit, or on the first login to a unit that has been
reset to full default configuration, the Set Country Code page is displayed
(Figure
6
The web interface menu and System Summary page are displayed
6-9). Continue with configuration.
6-6
If the power supply is a PIDU, the Ethernet LED does not illuminate.
(Figure
6-7). Enter and confirm the new Password.
6-8). Select the Country Code and select OK to confirm it is correct.
CAUTION
Ensure the correct Country Code is selected. An incorrect selection
may result in illegal radio operation. Once set, the Country Code can
only be changed by using the reset switch, as described in
default configuration (with country reset)
Chapter 6 Configuration and alignment
(Figure
(Figure
6-6), enter the Username 'admin'
on page 7-26.
6-4). Tick the
(Figure
6-5),
Resetting to
(Figure
phn-2182_002v000
May 2011
Advertisement
Table of Contents
