Unloading tools
13.5.7
Selecting a magazine
You can directly select the buffer memory, the magazine, or the NC memory.
Procedure
Hiding magazines
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
1.
Place the cursor on the tool that you would like to unload from the
magazine and press the "Unload" softkey.
2.
Select the required load point in the "Load Point Selection" window.
3.
Confirm your selection with "OK".
- OR -
Undo your selection with "Cancel".
1.
The tool list is opened.
2.
Press the "Magazine selection" softkey.
If there is only one magazine, you will move from one area to the next
(i.e. from the buffer memory to the magazine, from the magazine to
the NC memory, and from the NC memory back to the buffer memory)
each time you press the softkey. The cursor is positioned at the
beginning of the magazine each time.
- OR -
If there is more than one magazine, the "Magazine Selection" window
opens. Position the cursor on the desired magazine in this window
and press the "Go to ..." softkey.
The cursor jumps directly to the beginning of the specified magazine.
Tool management
13.5 Tool list
553