Siemens sinumerik 840D sl Operating Manual page 467

Parameters
ZV
Blank
XA
XI
ZA
ZI
ZB
N
SW or L
W
L
S
Counterspindle
Work offset
Write to the
work offset
ZV
Blank
ZA
ZI
ZB
XA
XI
N
SW or L
W
L
S
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Description
Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please refer to the machine manufacturer's instructions.
Tube

Cylinder

Polygon

Centered cuboid

Outside diameter ∅ – for tube and cylinder
Inside diameter (abs) or wall thickness (inc) – only for tube
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Number of edges – only for polygon
Width across flats or edge length – only for polygon
Width of the blank - only for centered cuboid
Length of the blank - only for centered cuboid
Speed limitation of the main spindle
Selecting the work offset
Yes

Parameter ZV is displayed
No

Parameter ZV is not displayed
Z value of the work offset
For G54, the Z value is entered into the work offset.
Tube

Cylinder

Polygon

Centered cuboid

Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Outside diameter – (only for tube and cylinder)
Inside diameter (abs) or wall thickness (inc) – (only for tube)
Number of edges – (only for polygon)
Width across flats or edge length – (only for polygon)
Width of the blank - (only for centered cuboid)
Length of the blank - (only for centered cuboid)
Speed limitation of the counterspindle
Multi-channel support
9.3 Multi-channel editor
Unit
mm
mm
mm
mm
rev/min
mm
mm
mm
mm
rev/min
467