Contour Pocket/Contour Spigot (Cycle63/64) - Siemens sinumerik 840D sl Operating Manual

Turning
Hide thumbs Also See for sinumerik 840D sl:
Table of Contents

Advertisement

Parameters
Description
axis-by-axis
Retraction
strategy
spatial
R2
Retraction radius - (only for "quadrant or semi-circle" retraction)
L2
Retraction distance - (only for "straight line" retraction)
Lift mode
If more than one depth infeed is necessary, specify the retraction height to which the
tool retracts between the individual infeeds (at the transition from the end of the contour
to the start).
Lift mode before new infeed
No retraction
to RP
Z0 + safety clearance
By the safety clearance
FR
Retraction feedrate for intermediate positioning
FS
Chamfer width for chamfering - (only for chamfering machining)
ZFS
Insertion depth of tool tip (abs or inc) - (for chamfering machining only)
8.5.8

Contour pocket/contour spigot (CYCLE63/64)

Contours for pockets or islands
Contours for pockets or islands must be closed, i.e. the starting point and end point of the
contour are identical. You can also mill pockets that contain one or more islands. The islands
can also be located partially outside the pocket or overlap each other. The first contour you
specify is interpreted as the pocket contour and all the others as islands.
Automatically calculating/Manually entering the starting point
Using "Automatic starting point" you have the option of calculating the optimum plunge point.
By selecting "Manual starting point", you define the plunge point in the parameter screen.
If the islands and the miller diameter, which must be plunged at various locations, are
obtained from the pocket contour, then the manual entry only defines the first plunge point;
the remaining plunge points are automatically calculated.
Contours for spigots
Contours for spigots must be closed, i.e. the starting point and end point of the contour are
identical. You can define multiple spigots, which can also overlap. The first contour specified
is interpreted as a blank contour and all others as spigots.
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Programming technology functions (cycles)
8.5 Contour milling
Unit
mm
mm
mm
mm
395

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828d

Table of Contents