Bep Troubleshooting Flow Chart; Rebooting Or Shutting Down Troubleshooting Flow Chart - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
7-9-9-2

BEP Troubleshooting Flow Chart

Use the Flow Chart isolate cause/failure(s).
Figure 7-161 Rebooting or Shutting Down Troubleshooting Flow Chart
NOTE: If unfamiliar with the Boot Up
Sequence, see: 7-9-9-3 "Boot up
sequence" on page 7-230.
1. Perform Minimum Configuration Steps.
START
2. Reboot.
Issue is likely to be with the Card Rack, or the BEP I/O
to Backplane Cable, or the PCIe Cable to GFI.
Troubleshoot these components.
Problem was a Base Load Image and
Application Software issue.
Monitor site for a reoccurrence.
Minimum Configuration Steps
1. Power-down and disconnect the mains
power cable from the wall outlet.
2. GFI - Disconnect the BEP I/O to
Backplane Cable (cable that connects the
I/O Board to the Card Rack).
3. GFI - Disconnect the GFI Cable (PCIe to GFI 2).
2-3. MRX - Disconnect the BEP to MRX
Backplane Cable.
4. Disconnect the DVD Drive and
DVD power (SATA 1 Cable - DVR).
5. Disconnect the DVR, if present (inside the
BEP, next to the Video Card).
6. Disconnect the V Nav, if present (Bay Bird).
7. Disconnect the Patient I/O,
if present (Harness inside the BEP).
8. Power-up. System should reboot three times
because it is looking for the Card Rack, then
should be in Simulator Mode.
- The 48VDC to the XYZ be removed.
- DVI to the LCD and J22 to the Upper Op Panel.
PROPRIETARY TO GE
. 7
EV
System boots to simulator mode.
Problem not present.
Problem not present.
Occurs later.
Replace HD.
Chapter 7 Diagnostics/Troubleshooting
LOGIQ E9 P
Problem persists.
1. Reconnect DVD Cables.
2. Reload Base Load Image and
Application Software.
Pass, but problem
persists.
Order HD and BEP.
Problem persists.
Determine which causes problem,
HD or BEP and return unneeded
new part.
Contact OLC,
or ZSE.
S M
ROPRIETARY ERVICE ANUAL
Problem persists.
Run HD Surface Test.
Fails
Replace HD.
Problem not
present.
Finished.
7 - 227