Huawei SmartAX MA5603T Configuration Manual page 475

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
5.
6.
7.
8.
Step 9 Configure the SHDSL service.
The MA5600T/MA5603T/MA5608T supports the SHDSL service of multiple encapsulation
modes, such as IPoA, PPPoA, IPoE, and PPPoE. This topic takes the PPPoE mode as an example
to describe how to configure the SHDSL service. For other encapsulation modes, see
Example: Configuring the xDSL Internet Access
1.
Issue 01 (2014-04-30)
Configure the ADSL2+ alarm profile.
You can configure the ADSL2+ alarm profile based on your requirements. For detailed
configuration, see "Configuring an ADSL2+ Alarm Template." This example adopts the
default alarm profile 1 in the system.
Configure the ADSL2+ traffic profile.
You can configure the ADSL2+ traffic profile by running the traffic table ip command
based on your requirements.
In this example, the default profile (profile 6) is used.
Activate the ADSL2+ port.
huawei(config)#interface adsl 0/2
huawei(config-if-adsl-0/2)#deactivate all
huawei(config-if-adsl-0/2)#alarm-config all 1
huawei(config-if-adsl-0/2)#activate all template-index 1
huawei(config-if-adsl-0/2)#quit
Configure the upstream port.
l Configure the GIU board.
The configuration of the upstream port of the GIU board should be the same as that
of the peer device.
Run the auto-neg command to set the port to work in the auto-negotiation mode.
If the port does not work in the auto-negotiation mode, change to the GIU config
mode and run the speed command to change the port rate, and run the duplex
command to change the port duplex mode.
l Configure the VLAN.
The ADSL2+ users of MA5600T/MA5603T/MA5608T-1 use the VLAN
authentication. In this case, the MUX VLAN is used to identify the users.
huawei(config)#vlan 1000 to 1031 mux
huawei(config)#port vlan 1000 to 1031 0/19 0-2
huawei(config)#port vlan 60 to 62 0/19 0-2
Add the service port.
All ports in slot 0/3 provide the ADSL2+ service. To add service ports in batches, run the
multi-service-port command.
huawei(config)#multi-service-port from-vlan 1000 port 0/2 0-31 vpi 0 vci 35 rx-
cttr 6 tx-cttr 6
Configure the SHDSL line profile.
To configure the SHDSL line profile, run the shdsl line-profile add or shdsl line-profile
quickadd command.
huawei(config)#shdsl line-profile quickadd 10 line two-wire rate 2048 2048
psd
symmetric transmission Annex-A remote disable probe disable snr-margin ds-curr
10 ds-worst
10 us-curr 10 us-worst 10 bitmap 0x03
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Example of MSTP Subtending Network
Service."
"3.1
450