Huawei SmartAX MA5603T Configuration Manual page 893

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Data plan
Item
Port
Service VLAN
Traffic profile
Procedure
Step 1 Log in to and configure the ONU.
You can remote log in to the ONU from the OLT to perform the configuration. The user name
is root and the password is mduadmin.
Step 2 Create SVLANs.
Create smart SVLANs 1001-1016 in batches with attribute common.
huawei(config)#vlan 1001-1016 smart
Step 3 Add the upstream port to SVLANs.
Add upstream port 0/0/1 to SVLANs.
huawei(config)#port vlan 1001-1016 0/0 1
Step 4 Configure a traffic profile.
Run the display traffic table ip command to query the existing traffic profiles in the system. If
the existing traffic profile in the system does not meet the requirement, run the traffic table ip
command to add a traffic profile.
Assume that the committed information rate (CIR) is 4 Mbit/s, priority of upstream packets is
0, and downstream packets are scheduled based on the priorities specified in the traffic profile.
Configure traffic profile 8.
huawei(config)#traffic table ip index 8 cir 4096 priority 0 priority-policy local-
Setting
Step 5 Add a service port.
Create service port 101, bind it to port 0/3/1, set the user-side VLAN to untagged and bind the
VLAN to traffic profile 8.
Issue 01 (2014-04-30)
Data
Upstream port: 0/0/1
Service port: 0/3/1
VLAN ID: 1001-1016
VLAN type: smart VLAN
VLAN attribute: common
Profile ID: 8
Committed rate: 4 Mbit/s
Priority: 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Remarks
-
The ONU supporting 16 FE ports is
used as an example. In actual
configuration, plan the data according
to actual capabilities of devices.
For details about the data plan, see
11.2.3 Principle of Internet Access
Service Data Plan.
For details about the data plan, see
11.2.2 Principle of QoS Data Plan.
868