SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End
9.7.2.5 Configuring the Voice Service
The OLT is connected to the remote ONT through a GPON port to provide users with the IP-
based high-quality and low-cost VoIP service.
Prerequisites
l
l
l
l
l
Data Plan
Item
ONT line profile
Issue 01 (2014-04-30)
Parameter
VLAN
enabling
VLANID
[1-4094]
Binding item
Mode
c.
Click OK.
3.
Restart the HGW.
Choose Management > Device Management and click Restarting the Device.
The SIP interface data and POTS user configuration data corresponding to the MG interface
have been configured on the SIP server.
The connection between the OLT and the SIP server is set up. The OLT can ping the IP
address of the SIP server successfully.
The ONT has been added to the OLT. For details, see
OLT.
HGWs have different models and appearances but their configuration procedures are
similar. This topic uses the HG255 that uses LAN for upstream transmission as examples.
The IADs use SIP as the voice protocol.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
Enabled: Upstream packets contain VLAN tags.
Disabled: Upstream packets do not contain VLAN tags.
NOTE
If uservlan is set to untagged when you configure a service flow for
the Internet access service on the OLT, set this parameter to
Disabled; otherwise, set it to Enabled.
If VLAN enabling is set to Enabled, this parameter takes
the value of uservlan that is specified when you configure a
service flow for the Internet access service on the OLT.
LAN1 and LAN2: PCs connected to ports LAN1 and LAN2
can simultaneously access the Internet.
Bridge: PCs access the Internet in PPPoE dial-up mode.
Data
Profile name: ftth
T-CONT ID: 4
GEM port ID: 12
9 FTTH Configuration
9.7.1.3 Adding an ONT to an
638