Magazine Description Data For Tool Management - Siemens sinumerik 840d Programming Manual

Tables
15
15.2 List of system variables
Identifier Type
$TC_MDP1 INT
INT
$TC_MDP2
INT
$TC_MLSR
$TC_MPTH INT
15.2.12

Magazine description data for tool management

$TC_MAP2 STRIN
G
INT
$TC_MAP1
INT
$TC_MAP3
$TC_MAP4 INT
15-532
Description: System variable/value range/index
$TC_MDP1[n,m]
Distance between change position of magazine n and location m of
1st internal magazine
internal mag. 1 distance parameter
n: Physical Magazine number
m: Physical location number
$TC_MDP2[n,m]
Distance between change position of magazine n and location m of
2nd internal magazine
internal mag. 2 distance parameter
n: Physical Magazine number
m: Physical location number
$TC_MLSR[n,m]=0
Assignment between buffer location n and buffer location m
m must identify a location of type 'spindle'.
N must identify a location not of type 'spindle'.
This permits definition of the grippers are assigned to
which spindles. The parameter value fix = 0.
The write process defines a relation, the read process checks
whether a particular relation applies. If not, an alarm is produced
during a read operation.
Define links of grippers,... to spindles.
N: Physical magazine location number of location class not equal to
SPINDLE
m: Physical magazine location number of location class equal to
SPINDLE
$TC_MPTH[n,m]
Magazine location type hierarchy
mag.location (place)types hierarchy parameter
n: Hierarchy 0 – 7
m: Location type 0 – 7
$TC_MAP2[n]
Identifier of the magazine
n: Magazine number 1 to ...
$TC_MAP1[n]
Type of magazine
n: Magazine number 1 to ...
$TC_MAP3[n]
State of magazine
n: Magazine number 1 to ...
$TC_MAP4[n]
Chaining with following magazine
n: Magazine number 1 to ...
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
04.00
15
Part pro Sync O S
R W 2
R W 2
R W 3
R W 3
R W 2
R W 2
R W 2
R W 2
 Siemens AG 2000. All rights reserved