Siemens sinumerik 840d Programming Manual page 487

12.98
15
CLAL Clear alarm
CLEARM Reset one/several markers for channel
coordination
CLGOF Const. workpiece speed for centerless grinding OFF
CLGON Const. workpiece speed for centerless grinding ON
CLRINT Deselect interrupt
CMIRROR Mirror on a coordinate axis
1,6
Compressor OFF
COMPOF
6
Compressor ON
COMPON
COMPCURV
Compressor ON constant curve polynomials
CONTPRON Activate contour preparation
(contour preparation ON)
COS Cosine (trigon. function)
COUPDEF Definition ELG group / synchronous spindle
group
(couple definition)
COUPDEL Delete ELG group (couple delete)
COUPOF ELG group / synchronous spindle pair OFF (couple OFF)
COUPON ELG group / synchronous spindle pair ON (couple ON)
COUPRE Reset ELG group
S (couple reset)
CP Path movement (continuous path)
CPRECOF Programmable contour precision OFF
1,6
6
Programmable contour precision ON
CPRECON
CPROT Channel-specific protection zone ON/OFF
CPROTDEF
Channel specific protection area definition
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15.1 List of instructions
INT Parameter: Alarm
number
INT, Does not influence
1 - n machining in own
channel
INT Parameter:
Interrupt number
FRAME
Real
String Block change
(software)
response:
NOC: no software
control,
FINE/COARSE:
software on
"Synchronization
fine / coarse",
IPOSTOP: software
on setpoint-
dependent
termination of
overlaid movement
Programmed
values invalid;
machine data
values valid
Tables
15
m 30
m 30
m 30
m 49
m 49
m 39
m 39
15-487