Fujitsu M10 Installation Manual page 370

Table C-1 XSCF setup command examples (continued)
XSCF command example
showhardconf -u
showlogs error
showstatus
Creating an XSCF user
showpasswordpolicy
setpasswordpolicy -y 3 -m
8 -d 2 -u 0 -l 0 -o 0 -M 60
-w 15
adduser jsmith
password jsmith
setprivileges jsmith
useradm platadm
showuser -l
Configuring the Telnet/SSH/HTTPS service
showtelnet
settelnet -c enabled
showssh
setssh -c enabled
setssh -c genhostkey
showhttps
sethttps -c enable
Configuring the XSCF network
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
356
Description
Displays the number of mounted
units by FRU
Displays an error log
Displays information on a degraded
unit
Displays the password policy settings
Sets the system password policy
Example: The following is set: a retry
count of 3, a password length of 8
characters including at least 2
numeric characters, an expiration
time of 60 days, and 15 days ahead
for the start date for warnings before
the password expires.
Creates a user account
Sets a password
Assigns a user privilege
Checks information on a created user
account
Displays the Telnet service status
Starts the Telnet service
Displays SSH service information
Starts the SSH service
Generates a host key
Displays the HTTPS service status
Starts the HTTPS service
Mandatory? Linked section
No "6.8 Checking the Component
Status"
Yes "6.8 Checking the Component
Status"
Yes "6.8 Checking the Component
Status"
No "7.1 Setting the Password
Policy"
Yes "7.1 Setting the Password
Policy"
Yes "7.2 Setting a User Account
and Password"
Yes "7.2 Setting a User Account
and Password"
Yes "7.2 Setting a User Account
and Password"
No "7.2 Setting a User Account
and Password"
No "7.3.1 Configuring the Telnet
service"
Optional "7.3.1 Configuring the Telnet
service"
No "7.3.2 Configuring the SSH
service"
Optional "7.3.2 Configuring the SSH
service"
Optional "7.3.2 Configuring the SSH
service"
No "7.4 Configuring the HTTPS
Service"
Optional "7.4 Configuring the HTTPS
Service"