Fujitsu M10 Installation Manual page 205

*1 For a CMU on which the SPARC64 X+ processor is mounted, "Type: B" is displayed. For a CMU on which the SPARC64 X processor is
mounted, "Type: A" is displayed.
*2 If the SPARC64 X+ processor is mounted, "3.700 GHz; Type:0x20" is displayed. If the SPARC64 X processor is mounted, "3.000 GHz;
Type:0x10" is displayed.
1.
Confirm that no FRU has an asterisk (*) displayed in front of it.
The asterisk (*) is a mark indicating the abnormal state of an FRU, where an
error or degradation occurred.
If a failure has occurred in any unit, see
and
degradation
2.
Execute the showhardconf -u command.
The command displays the quantities of mounted FRUs. However, it does not
display the quantities of I/O-related components such as PCI cards and PCI
expansion units while the system power is off.
Example: SPARC M10-1 display example
XSCF> showhardconf -u
SPARC M10-1; Memory_Size:1024 GB;
+-----------------------------------+------------+
| FRU | Quantity |
+-----------------------------------+------------+
| MBU | 1 |
| Type:B | ( 1) |
| CPU | 1 |
| Freq:3.200 GHz; | ( 1) |
| MEM | 16 |
| Type:47; Size:64 GB; | (16) |
| PCICARD | 0 |
| LINKCARD | 0 |
| PCIBOX | 0 |
| IOB | 0 |
| LINKBOARD | 0 |
| PCI | 0 |
| FANBP | 0 |
| PSU | 0 |
| FAN | 0 |
| OPNL | 1 |
| PSUBP | 1 |
| PSU | 2 |
| FANU | 7 |
+-----------------------------------+------------+
Example: SPARC M10-4S display example
XSCF> showhardconf -u
SPARC M10-4S; Memory_Size:2048 GB;
+-----------------------------------+------------+
| FRU | Quantity |
+-----------------------------------+------------+
"A.2.3 Checking information on a component where a failure or
occurred."
"A.2.2 Checking the contents of
Chapter 6 Performing an Initial System Diagnosis
logs"
191