2.
Execute the showcod command, and confirm the number of assigned CPU
Activations.
The following example assigns four CPU cores to physical partition 0.
XSCF> showcod -v -s cpu
PROC Permits installed : 4 cores
PROC Permits assigned for PPAR 0: 4 [Permanent 4cores]
PROC Permits assigned for PPAR 1: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 2: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 3: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 4: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 5: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 6: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 7: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 8: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 9: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 10: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 11: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 12: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 13: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 14: 0 [Permanent 0cores]
PROC Permits assigned for PPAR 15: 0 [Permanent 0cores]
3.
Similarly assign CPU core resources to all of the physical partitions.
7.13
Starting and Stopping a Physical
Partition (PPAR)
Check the start and stop of a physical partition (PPAR). For the initial settings,
change the auto-boot? setting to "false" so that Oracle Solaris does not automatically
boot immediately after the start of the physical partition.
1.
Execute the setpparparam command to change the auto-boot? setting, which
is an OpenBoot PROM environment variable.
XSCF> setpparparam -p 0 -s bootscript "setenv auto-boot? false"
OpenBoot PROM variable bootscript will be changed.
Continue? [y|n] : y
2.
Execute the poweron command to start the physical partition.
XSCF> poweron -a
PPAR-IDs to power on:00,01
Continue? [y|n]: y
00:Powering on
01:Powering on
Chapter 7 Making the Initial System Settings
223