Installing Microham Usb Device Router - microHAM microKEYER II User Manual

Hide thumbs Also See for microKEYER II:

User manual (49 pages)

Table Of Contents

Table of Contents

7. For Icom transceivers, open MK II and install the ICVOX jumper located behind the

PTT IN jack. Otherwise, connect your transceiver PTT Out (linear) to the PTT IN

jack using the supplied RCA to RCA cable.

8. If you use a foot switch, connect the foot switch to the FOOTSW jack.

9. If your transceiver's accessory port is capable of supplying +13.8 V at 500 mA, you may

install the DB37 Power jumper located in the right rear corner just in front of the +13.5 V

DC jack.

NOTE: Beginning with serial number 900, this header was converted to three

positions. Connecting the left pair of terminals selects the 1.38V power jack while

connecting the right pair of terminals selects power from the DB37 jack.

WARNING: DO NOT use DB37 Power input with Yaesu transceivers or if the

Accessory power is less than 12 Volts when transmitting (Elecraft K3).

10. Connect a 12 to 16V DC supply to the DC 13.8V jack.

Be sure to observe the proper polarity.

11. Locate but

DO NOT

The Windows setup utility will start and ask into

which folder Router and its supporting files should

be installed. Note: unless you have a very strong

reason to install Router elsewhere, please accept

the default location.

When the Router installation is completed, click

"Finish" to launch Router for the first time. Then

plug in the USB cable and proceed to configuring

Router for your station and software.

connect the USB cable to the MK II at this time.