Dvk Tab - microHAM microKEYER II User Manual

microHAM © 2010 All rights reserved

DVK TAB

microKEYER II allows recording and playing an unlimited number of messages (limited only by the capacity
of the computer hard drive) - nine voice messages per bank. Banks can be managed with Rename, Add
and Remove buttons. Rename to rename the current bank, Add to create a new bank, and Remove to
delete the current bank. Bank selection is provided by Bank box.
Each memory may repeat with a programmable delay
(loop) or can be chained with another memory using
external keyboard or keypad.
While a DVK message is being recorded or played
microKEYER II uses the DVK mixer settings. When
recording or playback is done, the settings in the Audio
Mixer are restored. DVK mixer settings are not stored
with presets but in the message banks. This means
each bank can have its own levels (slider position). It
also allows each bank to be configured for the voice of
a different operator if microKEYER II is used in a club
station or other multi-operator situation.
DVK memories can be recorded or played under logger
control if your logger supports microHAM Control
Protocol.
Under Windows 2000 or XP, Router DVK uses the
sound card defined on the Audio Mixer Tab.
For Vista and Windows 7, select:
REC MIC: "Headset Microphone (microHAM CODEC)"
TX: "Headset Earphone (microHAM CODEC)"
REC MIC slider adjusts microphone level during
message recording.
TX: The Left Master/Wave controls operate the same
as the TX VOICE/DIGITAL controls on the Audio Mixer
tab. There will be only a single MASTER control under
Windows Vista.
If "On Air Recording" box is checked, the microphone
is connected to both the sound card and the transceiver input while messages are being recorded. On Air
Recording is not available in Windows Vista.
DO NOT use the foot switch or microphone PTT when recording.
41