Panasonic FP-D250 User Manual page 564

(2) Installation procedure
Remove all shipping materials before installation.
Caution : Make sure the copier is unplugged before the installation.
Location
1
2
2
3
3
4
1
6-38
Procedure
(1) Remove the copier rear cover.
(7 screws)
(1) Remove the hard disk mounting
bracket. (right) (2 screws)
Note : This bracket is for the
printer hard disk drive.
(FA-HD01)
(2) Remove the hard disk mounting
bracket. (left) (2 screws)
1
(1) Install the hard disk drive in the
front compartment (4 screws).
(2) Reinstall the hard disk drive
mounting bracket (left).
(3) Connect the IDE signal harness to
the IDE connector on the hard
disk drive.
(4) Connect the power supply har-
ness to the hard disk drive.
(5) Reinstall the hard disk bracket
(right). (2 screws)
2
(Connect the harness if the hard
disk drive for printer is installed.)
Check