NEC Univerge SV8100 Features And Specifications Manual page 82

Issue 1.0
Related Features
Call Forwarding
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
11-01-01 System Numbering – Service
Code
20-01-01 System Options – Operator
Access Mode
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
20-17-01 Operator Extension – Operator's
Extension Number
24-02-01 System Options for Transfer –
Busy Transfer
Operation
None
2 - 58
Description/Comments
Set the system internal (Intercom)
numbering plan. The numbering plan
assigns the first and second digits
dialed and affects the digits an
extension user must dial to access
other extensions and features, such
as service codes and trunk codes. If
the default numbering plan does not
meet the site requirements, use this
program to tailor the system
numbering to the site.
Assign the priority of a call when
calling an operator telephone.
Turns Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy.
Define the extension numbers which
are to be used by operators.
Use this option to Disable or Enable
extensions to Transfer calls to busy
extensions. If disabled, calls
transferred to busy extensions recall
immediately.
UNIVERGE SV8100
Assigned Data
Refer to System
Numbering Default
Settings table in the
UNIVERGE SV8100
Programming Manual
for a list of default
settings.
0 = Step
1 = Circular
(default = 0)
0 = Off
1 = On
(default = 0 for
COS 1~15)
Up to eight digits
(default = ext. 101)
0 = Disable
1 = Enable
(default = 1)
Attendant Call Queuing
Level
1 2 3