NEC Univerge SV8100 Features And Specifications Manual page 751

UNIVERGE SV8100
Program
Program Name
Number
80-01-01 Service Tone Setup – Repeat
(48) Count
80-01-02 Service Tone Setup – Basic Tone
(48) Number
Operation
To leave a Message Waiting:
1. Call busy or unanswered extension.
2. Dial 0 or press the Message Waiting key (Program 15-07 or SC 751: 38).
3. Hang up.
With multiline terminal telephones, the Message Waiting LED lights.
To answer a Message Waiting:
When you have a message, your Message Waiting LED flashes fast for multiline terminals.
1. At the multiline terminal, press Speaker and dial 0.
- OR -
Press the Message Waiting key (Program 15-07 or SC 751: 38).
- OR -
At the single line telephone, lift the handset and dial 0.
If the called extension does not answer, dial 0 or press your Message Waiting key to automatically leave them a
message.
Normally, your Message Waiting LED goes out. If it continues to flash, you have new messages in your Voice Mail
mailbox or a new General Message. See "To check your messages" below.
To cancel all your Messages Waiting:
This includes messages you have left for other extensions and messages other extension have left for you.
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 773.
SV8100 Features and Specifications Manual
Description/Comments
Set repeat count for tone 16
Lockout.
Use to customize Service Tones.
Assigned Data
1
0~255 (default 0 = until
On-Hook)
Refer to Table 2-14
Service Tone Setup,
Program 80-01-01 on
page 2-555
(default = 0)
Refer to Table 2-15
Service Tone Setup,
Program 80-01-02 on
page 2-558.
Issue 1.0
Level
2 3
2 - 727