Radio And Television Interference - Mitsubishi Electric Apricot Owner's Handbook Manual

S a f e t y a n d R e g u l a t o r y N o t i c e s
Refer to the labels on the rear of the computer to establish which of the following
warnings apply.
FCC Class A
Warning - this equipment has been tested and found to comply with the limits for a Class
A computing device, pursuant to Subpart J of Part 15 of FCC rules. Only peripherals
(computer input/output devices, terminals, printer, etc.) certified to comply with the Class
A limits may be attached to this computer. Operation of this equipment in a residential
area may cause unacceptable interference to radio and television reception requiring the
operator to take whatever steps are necessary to correct the interference.
FCC Class B
Warning - this equipment has been certified to comply with the limits for a Class B
computing device, pursuant to Subpart J of Part 15 of FCC rules. Only peripherals
(computer input/output devices, terminals, printer, etc.) certified to comply with the Class
B limits may be attached to this computer. Operation with non-certified peripherals is
likely to result in interference with radio and TV reception.

Radio and television interference

The computer described in this manual generates and uses radio frequency energy for its
operation. If it is not installed and used properly, in strict accordance with the manual, it
may cause interference with radio and television reception.
The computer has been tested and found to comply with the RF emission limits for an
FCC Class B computing device which is intended to provide reasonable protection against
such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference with radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
♦
Move the computer away from the receiver being interfered with.
♦
Turn the computer with respect to the receiver.
♦
Turn the receiver with respect to the computer.
♦
Plug the computer into an outlet that is on a different branch circuit from the
receiver.
♦
Disconnect and remove any I/O cables that are not being used.
♦
Unplug and remove any expansion cards that are not being used, and replace the
relevant blanking plates.
♦
Make sure that the computer is plugged into a grounded outlet.
If you need additional help, consult your supplier. You may find the following booklet
helpful: How to Identify and Resolve Radio-TV Interference Problems. This booklet is
available from the US Government Printing Office: Washington DC 20402 - Stock No.
004-000-000345-4.
DOC Class A
The computer described in this manual complies with: Canadian DOC radio interference
regulations CRCc 1374 governing Class A digital devices.
DOC Class B
The computer described in this manual complies with: Canadian DOC radio interference
regulations CRCc 1374 governing Class B digital devices.
IV OWNER'S HANDBOOK