Table of Contents
Advertisement
S e r v i c e I n f o r m a t i o n
6.
Reach behind the bezel and disconnect the ribbon cable from the
front panel.
Fitting
1.
Ensure that the hard disk drive module closest to the front of the
machine (module 1) is removed.
2.
Plug the ribbon cable into the connector on the front panel.
3.
Fit the bezel onto the chassis and connect the eight screws, four on
each side of the server, as shown in the following diagram:
1
Figure 4-13 Refitting Front Bezel
1.
Front Bezel
2.
Front Panel System
Controller Connector
4-14 OWNER'S HANDBOOK
2
COMPAC
T
Cass ette
Drive
Open /Clos
e
SL O T-
4
DC
Write Prote
ct
Step
3.
Securing Screws (x 8)
3
Advertisement
Table of Contents
