Table of Contents
Advertisement
O p e r a t i n g Y o u r S y s t e m
How to use the SCU
The Help text will provide most of the instructions you will need to use
the SCU. The following paragraphs briefly explain the general techniques
for navigating your way through the utility.
Using menus and selection screens
♦
To select an option from a menu or selection screen, use the UP or
DOWN ARROW key to move the highlight to the option and press
the ENTER key. For example, use this procedure for Steps 1-6 on
the Main Menu.
Note
The fact that the Main Menu options are listed as numbered steps does not
necessarily imply that you must select them in numerical order every time you run the
SCU. However, if you have made changes to the existing configuration, you must
select Step 4: Save Configuration before you will be able to select Step 5: View
Switch/Jumper Settings.
♦
In addition to the menu options, most screens display defined keys
at the bottom of the screen, e.g. [Select=ENTER], or [Utilities=F9].
Press a defined key to initiate its corresponding action.
♦
Some screens contain vertical scroll bars on the right-hand edge,
which indicate that there is more information than one screen can
accommodate. You can use UP or DOWN ARROW to scroll
through the information. If you need to scroll quickly through a
series of screens, use PAGE UP or PAGE DOWN.
♦
When you select Step 5: View Switch/Jumper Settings, the
screen will display information for one board at a time. Press PAGE
DOWN to advance to the next board. If all the information for a
single board cannot be accommodated on one screen, pressing
PAGE DOWN will first scroll through to the end of the information
for that board and then pressing it again will advance to the next
board. PAGE UP does the same in reverse.
♦
Some screens contain toggle options, e.g. the screen for
[Utilities=F9] from the Main Menu. To turn a toggle option on or
off, move the highlight to the option and press the SPACEBAR. A
tick mark in the square brackets indicates that the option is in force.
♦
You can also use the mouse to select options, activate defined keys
and use scroll bars. Just point with the mouse cursor on the item and
click with the left mouse button. Clicking anywhere with the right
mouse button returns to the previous screen or, if you are at the
Main Menu, exits from the SCU. You must confirm your exit by
pressing ENTER or by clicking YES with the left mouse button.
When you have returned to the main menu, a tick mark to the left of the
option indicates that you have completed that step.
2-14 OWNER'S HANDBOOK
Advertisement
Table of Contents
