Installation Instructions - Blomberg KNM1561i Operating Instructions Manual

INSTALLATION
INSTRUCTIONS
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. This appliance has been designed
to operate in ambient temperatures up
to 32 degrees C (90 degrees F) and
is equipped with Advanced Electronic
Temperature Control System [AETCS]
which ensures that at the advised
setting [4 - four on the knob] the frozen
food in the freezer will not defrost
even if the ambient temperature falls
as low as -15 °C. When first installed
the product MUST NOT be placed in
low ambient temperatures because
the freezer will not reduce to it's
standard operating temperature. Once
it has reached its steady operating
state it can be re-located. So you
may then install your appliance in a
garage or an unheated room without
having to worry about frozen food in
the freezer being spoilt. However at
low ambient temperatures mentioned
above, fridge contents are likely
to freeze, so check and consume
food in the fridge accordingly. When
the ambient temperature returns to
normal, you may change the knob
setting to suit your needs.
If the ambient temperature is
below 0°C, the food in the fridge
compartment will freeze. So, we
recommend you don't use the fridge
compartment in such low ambient
conditions. You can continue using the
freezer compartment as usual.
3. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance
to work less efficiently. If installed
next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers
From Radiators 300 mm (12")
From Freezers 25 mm (1")
4. See pages 16 to 23 for detailed
Installation Instructions including
reversing door opening direction.
5. Refer to cleaning and care section
to prepare your appliance for use.
6. A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back
of the cabinet, on the side of the
compressor.
(See diagram) Gently remove the plug
from the receptacle. Never pull the
mains cord, you may damage the
appliance. In the case of
transportation,
ensure you locate the plug in the
receptacleprovided to avoid transit
damage.
10
EN
50 mm (2")