Table of Contents
Advertisement
"IMPORTANT: Make sure that mains
cable is not caught under the
appliance during and after carrying
/ moving the appliance, to avoid
the mains cable becoming cut or
damaged."
Do not allow children to play with the
appliance or tamper with the controls.
Blomberg declines to accept any
liability should the instructions not be
followed.
Replacing the interior light
bulb
To change the Bulb/LED used for
illumination of your refrigerator, call
your Authorised Service. The lamp(s)
used in this appliance is not suitable
for household room illumination. The
intended purpose of this lamp is to
assist the user to place foodstuffs in
the refrigerator in a safe and
comfortable way. The lamps used in
this appliance have to withstand
extreme physical conditions such as
temperatures below -20°C.
(only chest and upright freezer)
Installation instructions
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
C
If the ambient temperature is below
0°C, the food in the fridge will freeze.
So, we recommend you don't use the
appliance in such low ambient
conditions.
2. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
work harder. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers
From Radiators 300 mm (12")
From Freezers 25 mm (1")
3. Refer to "Maintenance and
cleaning" section to prepare your
appliance for use.
4. A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back
of the cabinet, on the side of the
compressor (see diagram). Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case of
transportation, ensure you locate the
plug in the receptacle provided to
avoid transit damage.
8
EN
50 mm (2")
Advertisement
Table of Contents
