Accelerator Cable Adjustment; Idle Speed Inspection - Suzuki Swift User Manual

6E1-8 ENGINE AND EMISSION CONTROL SYSTEM (TBI FOR G10)
ON-VEHICLE SERVICE
GENERAL
When the hoses have been disconnected and system's component
removed for service, be sure to reinstall component properly, and
route and connect hoses correctly after service. Refer to Emission
Control Information Label for proper connection of hoses (if
equipped).

ACCELERATOR CABLE ADJUSTMENT

1) Confirm that ambient temperature is higher than 0_C, 32_F.
2) Warm up engine to normal operating temperature with all elec-
tric loads OFF and stop engine.
3) Confirm that clearance "c" between throttle lever (1) and stop
screw (2) is less than about 1 mm (0.04 in.).
4) Check accelerator cable for play.
Accelerator cable play "a": 10 – 15 mm (0.4 – 0.6 in.)
Cable play should be within specification. If out of specification,
loosen accelerator cable lock nut and adjust by turning adjusting
nut (3). Be sure to tighten lock nut (4) securely after adjustment.
5) With accelerator pedal depressed fully, check clearance be-
tween throttle lever and lever stopper (5) (throttle body) which
should be within following specification.
Clearance "b": 0.5 – 2.0 mm (0.02 – 0.07 in.)
(With pedal depressed fully)
If measured value is out of specification, adjust it to specification
by changing height of pedal stopper bolt (6).

IDLE SPEED INSPECTION

Before inspecting idle speed, make sure to the following.
D Lead wires and hoses of Electronic Fuel Injection and engine
emission control systems are connected securely.
D After warming up engine, accelerator cable has some play, that
is, it is not tight.
D Ignition timing is within specification.
D All of electrical loads except ignition are switched off.
D Air cleaner has been properly installed and is in good condition.
D Malfunction indicator lamp does not light when engine running.
After above items are all confirmed, check idle speed as follows.