Suzuki Swift User Manual page 362

1
2
(a)
3
(a)
4
7
5
M / T
(a)
7
4
9
(a)
6. Rear mounting
1. Right mounting
7. Rear mounting
2. Right mounting
bracket
8. Rear torque rod
3. Left mounting
9. Rear torque rod
4. Left mounting bracket
5. Left mounting bracket
stiffener
INSTALLATION
(a)
1) Lift engine with transmission into engine compartment, but do
not remove support device.
2) Install engine right mounting to right mounting bracket and stiff-
ener.
3) Install engine left mounting to body.
6
4) Install rear mounting to body (For M/T model)
Install torque rod (For A/T model)
5) Tighten bolts and nuts of all parts installed in above steps 2),
3) and 4) or 5) to specified torque.
Tightening Torque
(a): 55 N
6) Remove support device.
7) Reverse removal procedures for installation of remainder.
D Push in each drive shaft joint fully so that snap ring engages
M/T
D Clamp electric wire securely.
8) Adjust clutch pedal free travel by referring to Section 7C. (M/T)
Adjust gear select cable and A/T throttle pressure control
cable, referring to Section 7B. (A/T)
(a)
9) Adjust gear shift control lever by referring to Section 7A. (M/T)
10) Adjust accelerator cable play by referring to Section 6E.
11) Refill transmission with gear oil. (A/T fluid for A/T model) by
8
referring to Section 0B.
12) Refill engine with engine oil by referring to Section 0B.
13) Refill cooling system by referring to Section 6B.
bracket
14) Adjust A/C compressor and/or P/S pump drive belt referring
to Section 0B. (if equipped)
bracket
15) Check P/S fluid level by referring to Section 3B1. (if equipped)
16) Upon completion of installation, verify that there is no fuel leak-
age, coolant leakage, transmission oil leakage or exhaust gas
leakage at each connection.
ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE) 6A1-67
.
m (5.5 kg-m, 40.0 lb-ft)
with differential gear or center bearing support.
Use care not to damage oil seal lip when inserting.