Map Sensor Individual Check - Suzuki Swift User Manual

6-1-44 ENGINE GENERAL INFORMATION AND DIAGNOSIS (SFI FOR G13)

MAP Sensor Individual Check

1) Disconnect coupler from MAP sensor (1).
2) Remove MAP sensor (1).
3) Arrange 3 new 1.5 V batteries (2) in series (check that total volt-
age is 4.5 – 5.0 V) and connect its positive terminal to "Vin" termi-
nal of sensor and negative terminal to "Ground" terminal. Then
check voltage between "Vout" and "Ground".
Also, check if voltage reduces when vacuum is applied up to 400
mmHg by using vacuum pump (3).
Output voltage (Vin voltage 4.5 – 5.5 V, ambient temp. 20 –
30_C, 68 – 86_F)
ALTITUDE
(Reference)
(ft) (m)
0 0
j j j j
2 000 610
2 001 611
j j j j
5 000 1 524
5 001 1 525
j j j j
8 000 2 438
8 001 2 439
j j j j
10 000 3 048
If check result is not satisfactory, replace MAP sensor (1).
4) Install MAP sensor (1) securely.
5) Connect MAP sensor (1) coupler securely.
BAROMETRIC
PRESSURE
(mmHg) (kPa)
760 100
j j j j
707 94
94
Under 707
j j
over 634
85
85
Under 634
j j
over 567
76
76
Under 567
j j
over 526
70
OUTPUT
VOLTAGE
(V)
3.3 – 4.3 3 3 4 3
3.0 – 4.1 3 0 4 1
2.7 – 3.7 2 7 3 7
2.5 – 3.3 2 5 – 3 3