Suzuki Swift User Manual page 370

A
Alphabets stamped
on mating surface B
of cylinder block
C
D If necessary, regrind crankshaft journal and select under-size
bearing to use with it as follows.
1) Regrind journal to the following finished diameter.
Finished diameter: 44.732 – 44.750 mm
2) Using micrometer, measure reground journal diameter.
Measurement should be taken in two directions perpendicular
to each other in order to check for out-of-round.
3) Using journal diameter measured above and alphabets
stamped on mating surface of cylinder block, select an under-
size bearing by referring to table given below.
Check bearing clearance with newly selected undersize bear-
ing.
44.744 – 44.750 mm
(1.7616 – 1.7618 in.)
Green & Red
Black & Red
Red only
Undersize bearing to be installed
Rear Oil Seal
Carefully inspect oil seal (1) for wear or damage. If its lip is worn or
damaged, replace it.
For oil seal installation, press-fit rear oil seal (1) so that oil seal
housing (2) end face is flush with oil seal end face.
ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE) 6A1-75
(1.7611 – 1.7618 in.)
Measured journal diameter
44.738 – 44.744 mm
(1.7613 – 1.7616 in.)
Black & Red
Red only
Yellow & Red
44.732 – 44.738 mm
(1.7611 – 1.7613 in.)
Red only
Yellow & Red
Blue & Red