Lock Washers/Plates And Cotter Pins; Bearings And Oilseals; Circlips - Yamaha T135SE Service Manual

1
1
1
1
3
2
4
IMPORTANT INFORMATION
EAS00023
LOCK WASHERS/PLATES AND COT-
TER PINS
After removal, replace all lock washers/plates 1
and cotter pins. After the bolt or nut has been
tightened to specification, bend the lock tabs
along a flat of the bolt or nut.
300-000
EAS00024

BEARINGS AND OILSEALS

Install bearings and oil seals so that the manu-
facturer's marks or numbers are visible. When
installing oil seals, lubricate the oil seal lips with
a light coat of lithium-soap-based grease. Oil
bearings liberally when installing, if appropriate.
1 Oil seal
300-003
cC
Do not spin the bearing with compressed air
because this will damage the bearing sur-
faces.
1 Bearing
300-002
EAS00025

CIRCLIPS

Before reassembly, check all circlips carefully
and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip
sharp-edged corner 2 is positioned opposite
the thrust 3 that the circlip receives.
300-001
4 Shaft
1-3
http://www.motorcycle.in.th
GEN
INFO
1 , make sure the