Password Setting - Sanyo VCC-ZM400P Instruction Manual

PRIVACY MASK SETTING (PRIVACY MASK)

PASSWORD setting

You can lock the privacy masks in place as gray patterns after they have been set. The password requirement is initially set to OFF, but to
begin using it, you must enter the factory set password "1234".
1
PRIVACY MASK SETTING
PASSWORD LOCK OFF ‚
PASSWORD CHANGE SET ‚
MASK SET SET ‚
MENU BACK
1
Use the cursor button (j or l) to move the cursor to
OFF for PASSWORD LOCK in the PRIVACY MASK
SETTING screen. Then press the SET button.
The PASSWORD screen will appear.
2
Enter the factory set password "1234".
Use the cursor button (j or l) to select "1", then use
the cursor button (c).
To move the cursor to the next "*" digit.
1¤¤¤
15
PASSWORD
¤¤¤¤ SET ‚
-
MENU BACK
3
PASSWORD
1234 SET ‚
-
OK
MENU BACK
3
Use the same steps to enter "2", "3" and "4", then press
the SET button.
"OK" will appear and BACK for MENU will be blinking. Press
the SET button again. The PRIVACY MASK SETTING screen
will reappear and "ON" will be blinking for PASSWORD LOCK.
Note: If a different password is required, "NG" will appear.
Please carefully maintain the password so that it will not be
forgotten.
PRIVACY MASK SETTING
PASSWORD LOCK ON ‚
PASSWORD CHANGE SET ‚
MASK SET SET ‚
MENU BACK