Installation; Transportation Instructions; Installation Instructions - Blomberg TSM 1541 Instruction Manual

3

Installation

TRANSPORTATION
INSTRUCTIONS
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of transport
the appliance has to be transported
horizontally, it must only be laid on its
right hand side when standing in the
frontof the appliance. After bringing
it to upright position,it must not be
operated for at least 4 hours to allow
the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
5. Empty any water in the drain
tray before moving see section
"Defrosting" and "Cleaning & Care"
for further information
IMPORTANT : Make sure the plastic
evaporating pan at the back of the
product collects water properly.
"IMPORTANT: Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal wires at the back of
theappliance as you might injure your
fingers and hands.
"IMPORTANT: This appliance is
not designed for stacking with any
otherappliance.When positioning your
appliance, take care not to damage
your flooring, pipes,wall coverings etc.
Do not move the appliance by pulling by
the door or handle.Do not attempt to sit
or stand on top of your appliance as it is
not designed forsuch use. You could injure
yourself or damage the appliance.
"IMPORTANT: Make sure that mains cable
is not caught under the applianceduring
and after carrying / moving the appliance,
to avoid the mains cablebecoming cut or
damaged."Do not allow children to play
with the appliance or tamper with the
controls.
BLOMBERG declines to accept any liability
should the instructions not be followed.

INSTALLATION INSTRUCTIONS

1. If possible avoid placing the appliance
near cookers, radiators or in direct
sunlight as this will cause the compressor
to run for long periods. If installed next to a
source of heat or refrigerator, maintain the
following minimum side clearances:
From Cookers
From Radiators 12" (300 mm)
From Refrigerators or Larder Fridge
1" (25 mm)
2. No gap is required at sides and top.
See item 3 below to ensure a gap is
obtained at the rear of the appliance. If
a gap is available on side and top, retain
it if possible as it would improve the air
circulation around the appliance.
3. Fit the two plastic wall spacers supplied with the
appliance rotating 1/4 turn to the condenser at the
back of the refrigerator (see diagram).
4. The fridge should be located on a
smooth surface. The two front feet can
be adjusted as required. To ensure that,
your fridge is standing upright adjust the
two front feet by turning clockwise or
anti-clockwise, until the product is in firm
contact with the floor. Correct adjustment
7
EN
2" (50 mm)