Table of Contents
Advertisement
Setting and Operating Outline
Ë Ë Ë Ë Ë Display when an NG image is captured
1
The controller automatically refreshes the NG image each time a new NG image is captured.
[An example of the split screen display (above and below)]
Measured
image from
Camera 1
NG image
from
Camera 1
Camera 1
capturing
image
Camera 1
NG image
Ë Ë Ë Ë Ë Display history of NG images (IV-S32M/S33M)
When the IV-S32M/S33M is used, move the cursor to the menu bar "NG-IMG-DISP" on the MAIN OPS
MENU, using the left and right key. Press the up and down keys to display previous NG images.
[An example of scrolling the split screen display (above and below)]
Display NG
image
history
When a new NG image is captured while displaying the history, it will be added to the history.
Note
- When "PARTIAL-IMG" is selected for image capturing (page 2-4), the NG images stored have
the maximum rectangular area set in measurements 0 to 4.
- When "CAM1&NG-IMG" is selected for the monitor output, only one camera* can be used for
each measurement (0 to 4) and for image pre-processing.
OK4 image
NG2 image
OK1
NG2
OK3
NG2
Measured
image from
camera 1
Up key
Down key
NG image number 9
- When a maximum of 10 NG images is registered.
* The camera connected to the camera 1 connector (CAMERA 1).
NG6 image
OK4
OK5
NG6
NG image number 10
1-20
OK7 image
Refreshes to NG6 image
OK7
OK8
OK9
NG6
Up key
Down key
NG image number 0
Advertisement
Table of Contents
