NEC Express5800 140Rd-4 User Manual page 69

5.
Fix t he slide rail assembly with four screws (two on each of the front and rear sides) and four washers (
of th e front and rear sides).
NOTES:
Make sure that the frame tips on the slide rail assembly are contact to the rectangular hole
frames of the rack properly and the four screw holes of the rail can be seen through the mating
rectangular holes of the rack
Check that the slide rail assembly is located to the level.
6.
Install the other slide rail assembly on the left side of the rack in the same procedure as that described by steps 7 to 8
above.
NOTE:
Make sure that the slide rail assembly is installed at the same level as the other slide rail
assembly already installed.
7.
Hol d the server by three or more persons to mount it on the rack.
Observe the following instructions to use the server safely. Failure to follow these instructions may
cause a fire, personal injury, or property damage. See pages 1-3 to 1-8 for details.
Do not lift the server only by two or less persons.
Do not pinch your fingers with mechanical component.
Do not push the release lever with fingers.
CAUTION
3-9
two on each