NEC Express5800 140Rd-4 User Manual page 238

8-36
Event logs in using SNMP Service in Windows Server 2003
Event Type:
Event Source:
Event Category: None
Event ID:
Description:
Event Type:
Event Source:
Event Category: None
Event ID:
Description:
→ The system will not be affect by these event logs. SNMP will not be affected either, so that you can
A PCI board is not recognized.
•
Is the PCI board installed correctly?
→ Confirm that the PCI board is installed in the slot correctly.
•
Is the proper IRQ assigned for the board?
→ Assign the proper IRQ by referring to the Chapter 4.
•
Is "Disabled" specified in [Option ROM] for the slot to install SCSI card (excluding the array board used
for operating system boot)?
→ Check the settings with the BIOS setup utility.
•
Is "Disabled" specified in [Option ROM] for the slot for added network board which is not used for
network boot?
→ Check the settings with the BIOS setup utility.
PCI hot-plug fails:
•
Is BIOS configuration correct?
→ You must change the BIOS configuration to use the PCI hot-plug feature.
The driver of a PCI board cannot be stopped from the operating system when Hot Remove or Hot Replace is executed
for the PCI board:
•
Is another software application using the PCI board for which Hot Remove or Hot Replace is to be
executed?
→ If another software application is using the PCI board for which Hot Remove or Hot Replace is to be
Warning
EvntAgnt
1015
TraceLevel parameter not located in registry;
Default trace level used is 32.
Warning
EvntAgnt
1003
TraceFileName parameter not located in registry;
Default trace file used is.
ignore these logs.
<Menus to check: [Advanced] - [PCI Configuration] - [PCI Slot n] (n: PCI slot number of installed
board) - [Option ROM Scan]>
<Menus to check: [Advanced] - [PCI Configuration] - [PCI Slot n] (n: PCI slot number of installed
board) - [Option ROM Scan]>
<Menus to check: [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] -
[Minimum/Middle/Maximum*]>
* Setting value depends on the board to be installed. See Chapter 4 for details.
<Menus to check: [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] - [Empty Bus Default
Speed] - [PCI Slots 5-6] or [PCI Slots 7-8] - Transfer speed of the board to be installed>
executed, the driver of the PCI board cannot be stopped.
Terminate the software, then stop the driver of the PCI board. If executing Hot Replace, restart the
software after having mounted a new PCI board.