NEC Express5800 140Rd-4 User Manual page 162

5-8
[Using the existing Configuration Disk]
The parameters files in the floppy disk are listed in dialogue-box.
1) Select a parameters file to use in the Express Setup, and then click [Use].
After the parameters file is specified, the message "Do you want to review or modify the Setup File parameters?"
appears.
2) If you want to modify or confirm the parameters file, click [Review]. If not, click [Skip].
Click [Review] → Go to next step.
Click [Skip] → Go to step 10.
[Using a blank disk]
1) Click the box under [Setup File Name: (A)] or press A.
The dialogue box appears.
2) Input the file name and click [Use].
9.
Confirm or modify the disk array configuration parameters.
[Configure RAID] screen appears. Confirm the specification, modify if necessary, and then click [OK].
NOTE: Choose RAID0 when you install it in one hard disk.
When the dialogue box is closed, the Express setup automatically performs the RAID configuration, creating
Maintenance partition and installing several utilities.
10.
Select the Operating system to install.
Select "Windows" from the menu.
11.
Select the Windows family.
Select "Microsoft Windows Server 2003 Standard Edition / Microsoft Windows Server 2003 Enterprise edition"
category.
NOTE: If you selected "Skip" at step 8, this menu does not appear, go to step 13.
12.
Next, [Basic Information] wizard appears. Confirm the parameters, modify if necessary, and then click [Next].
After that, click [Next], [Back], or [Help] on the screen to continue. Modify the parameters each time if necessary.
IMPORTANT:
Reserve the partition to install the operating system more than the minimally required size.
If you select "Use Existing Array" at "New/Existing RAID Configuration", the information
included in the first partition (excluding maintenance partition) will all be formatted and
deleted. The information included in the other partition will be retained. In the figure below,
describes the partition which information will be deleted when maintenance partition exists.
You cannot re-install the system with the existing partition that is upgraded to Dynamic Disk
remained. Do not select "Use Existing Array" at "New/Existing RAID Configuration".
If you specify other than 4095 MB for the "Installing Partition", it is necessary to convert to
NTFS.
If "Use Existing Array" at "New/Existing RAID Configuration" is selected but the partition
other than the one to install Windows Server 2003 does not exist (excluding maintenance
partition), Express Setup will reserve the maximum area of the hard disk to install Windows
Server 2003.
You cannot go to the next screen if the specification is incorrect.
On specification, an error may occur in relationship with the specified contents of the former
screen and require to go back to modify the specification.
First Partition
<Maintenance Partition>
Retained
Second Third Fourth
Partition Partition Partition
Deleted Retained Retained