NEC Express5800 140Rd-4 User Manual page 284

9-36
NOTES:
After installed the lon
The insulators are installed between
They are for protecting the PCI boar
damage the insulator when installing or
reinstall the insulator in place.
6.
Connect the c ables to the PCI board while firmly holding the PCI board with your hand.
7.
Slowly close the tab to secure the PCI board.
8.
Press the PCI hot plug switch.
Th PCI Slot Power lamp flashes once, and then goes on. e
NOTES:
If the server runs on Windows Serve
automatically recognizes the additiona
If an error occurred in the installed board o
9.
Reinstall the PCI slot cover and place the server into the rack.
10.
Take the following steps to
(1) Sele ct [Control Panel]
start the Device Manager.
(2) Move the cursor to the added board.
g board, secure it with the lock on the upper part of the guide rail.
the PCI board slots.
d already been installed. Take care not to remove o
removing the PCI board. If the insulator is taken of
r 2003 or Windows 2000, the operating system
lly installed PCI board and installs the driver.
r slot, the PCI Slot Fault lamp goes on (amb
check if the additionally installed PCI board is recognized and operating properly:
, [Administrative Tools], [Computer Management], and [Device Manager] in the order to
r
f,
er).